20-1-2010,morning:Today is the second day of our project car,we just only remove and dismantle the rear wheel lower arm to check the bushing and brake cylinder.Min Sun is our team leader so he responsibility to mark down any parts that need to be change and repair.
After our trainer finish his lesson, he start the half cut engine to make sure the engine is in good condition.This is the second day job. 
Ah siong and me is dismantle the rear lower arm
Lower arm
Gerald is open the door panel and test the power window
The whole lower arm and brake system is being dismantle
Jeng is busy dismantle the other side of the lower arm
Gerald is testing the power window
4 guys which is my teammate is take a rest
Open half cut ceremony by senior.It is my team project engine,Evo 3 head
Evo 3 head and my trainer adrian
Evo 3 engine,quite dirty because long time not being used
Evo 3 dashboard,air-con button fully digital
Evo 3 engine
Another side of Evo 3
Evo 3 engine
Another half cut engine, Mitsubishi Lancer GSR
Peter with Mitsubishi Lancer GSR
Ah siong and me is dismantle the rear lower arm
Lower arm
Gerald is open the door panel and test the power window
The whole lower arm and brake system is being dismantle
Jeng is busy dismantle the other side of the lower arm
Gerald is testing the power window
4 guys which is my teammate is take a rest
Open half cut ceremony by senior.It is my team project engine,Evo 3 head
Evo 3 head and my trainer adrian
Evo 3 engine,quite dirty because long time not being used
Evo 3 dashboard,air-con button fully digital
Evo 3 engine
Another side of Evo 3
Evo 3 engine
Another half cut engine, Mitsubishi Lancer GSR
Peter with Mitsubishi Lancer GSR
No comments:
Post a Comment